sdjclevland
PR Addict
Any one do this at all> I was thinking of getting it done with new spokes and colored nipples so i dont have to spend a ton of money.
powdercoating hubs
- Thread starter sdjclevland
- Start date
Mxracer517
PR Addict
anodizing IMO is the way to go alot thinner and seems to hold up better.....
sdjclevland
PR Addict
does it look the same or better? I want it to look glossy like not dull or flat.
pdracer440
PR Member
Have had a number of hubs powder and all turned out great. I would not recommend doing the spokes though.
sdjclevland
PR Addict
actually i got the hubs powercoated and i am just waiting for my spokes. I ggot red hubs with stainless steel spokes and red nipples
fmxpaul
PR Addict
As anyone that Powders knows, there are a TON of labor hours in this procedure. It's all in the Prep Work. If you bring me BARE CLEAN metal parts, I'll do it affordably. If you bring me oily, greasy, paint covered parts, it's not cheap. I do this for my own moto parts and I used to do quite a bit of it on the side, but now it's just for the bicycles, race car parts and my dirtbikes. I'm near 77 & Pleasant Valley. PM me for a number if you need something coated. My oven is pretty big, I've done Harley Softail frames & quad frames, so I know they fit.
